STM32 Thing Plus Hookup Guide
Contributors:
Alex the Giant, Ell C
Alex the Giant, Ell C 
Resources and Going Further
This should get you started with the STM32 Thing Plus. Need more information? Check out some of the links below:
Check out these other great Thing Plus tutorials from SparkFun:
ESP32-S2 Thing Plus Hookup Guide
Looking to use the more secure ESP32-S2? Follow this hookup guide to get started.
DA16200 Thing Plus Hookup Guide
A guide to get started with the DA16200 Thing Plus.
AzureWave Thing Plus (AW-CU488) Hookup Guide
The SparkFun AzureWave Thing Plus is a Feather form-factor development board equipped with the AW-CU488. We'll highlight key features of the board and show you to get started with the development board. A few Arduino examples will be highlighted to connect to a WiFi router, calculate the Fast Fourier Transform (FFT) from an input microphone, output an analog signal to a speaker, and connect an Qwiic-enabled device.
SparkFun Thing Plus - NINA-B306 Hookup Guide
A quick guide to get started using the SparkFun Thing Plus - NINA-B306. This Thing Plus is loaded with the Arm Cortex-M4 processor in the NINA-B306 along with on-board motion and environmental sensors in the ISM330DHCX 6DoF and BME280 pressure and temperature sensor.