Packet Tracer Tutorial # 1
89 likes118,483 views
The document provides instructions for setting up a network with 4 PCs connected to 2 switches, with the switches connected to a router. The key steps are: 1. Connect the PCs to the switches using copper cables and assign each PC an IP address from the same private IP range (e.g. 192.168.0.x). 2. Connect the switches to the router using copper cables. Configure the router interfaces with IP addresses from each private range and enable the ports. 3. Configure the default gateway of each PC to be the router IP that corresponds to its private IP range. 4. Add the private IP ranges to the router's RIP configuration to allow routing between the
Packet Tracer Tutorial # 1
- 1. Packet tracer Tutorial { Abdul Basit
- 2. Take 4 pc’s each side that will be connected by 2 switches 2950-24
- 3. Connect All of them With copper straight through cable
- 4. 10.0.01 To 10.255.255.254 172.16.0.1 To 172.31.255.254 192.168.0.1 To 192.168.255.254 If 2 computers want to communicate in a network they must have same type of address Assigning IP
- 5. Assign ip To pc’s in st network 1
- 6. Double click on Pc
- 7. Goto desktop tab and click ip configuration
- 8. Insert ip of the 1st pc subnet will automatically generate and leave the gateway right now
- 9. Ip of 2nd pc
- 10. IP of 3rd PC
- 11. IP of 4th PC
- 12. Remember i have inserted ip’s in all computer of same class 192.168.0._ “you need to limit yourself to one class of private addresses,however, if you want to computers to talk with each other” (joe-habraken)
- 13. Assign IP’s to the PC’s In the nd network 2 like 192.168.10.2 192.168.10.3 192.168.10.4 192.168.10.5
- 15. Connect One Generic Router Connect It With Swith 0 from fast ethernet 0/0, Connect It With Swith 1 from fast ethernet 1/0 With Copper straight through cabble
- 17. Router connectted with the network one from fast ethernet 0/0 1) double click on router 2) goto config tab 3) click fast ethernet 0/0
- 18. Insert ip of the class as the network 1 have So i inserts the ip 192.168.0.1 subnet will automatically generate make sue port status on
- 19. Router is configured with network 1
- 20. Insert getway of all pc’s in network one , the ip of router through which they are connected 192.168.0.1
- 21. Router connectted with the network 2 from fast ethernet 1/0 1) double click on router 2) goto config tab 3) click fast ethernet 1/0
- 22. Insert ip of the class as the network 2 have So i inserts the ip 192.168.10.1 subnet will automatically generate make sue port status on
- 23. Router is configured with network 1
- 24. Insert getway of all pc’s in network one , the ip of router through which they are connected 192.168.0.1
- 25. 1st network is 192.168.0.1 192.168.0.2 192.168.0.3 192.168.0.4 192.168.0.4 So add the rip address 192.168.0.0 And click add Add the rip address 192.168.10.0 For the 2nd network Add Router Information Protocol Double click on router Click config Tab Click rip
- 26. Pinging
- 27. Goto the command promt of any pc
- 28. Ping any IP of the network
- 29. Now what you see is
- 30. Thank You !i!i!